Brake Pad Replacement Reminder Reset - Procedure 02

NOTE: Perform PROCEDURE 01 first. If light does not reset, perform PROCEDURE 02. If the above procedures are not successful, connect vehicle to DIS tester, access Instrument Cluster/IKE, then "clear fault memory".

NOTE: For 5-Series, this procedure applies to vehicles with the Base Instrument Cluster.

NOTE: The base instrument cluster OIL SERVICE INSPECTION display is located on the bottom of the cluster, to the right of center. The base cluster is also equipped with a graphic display of the car that shows if a door or the trunk lid is open. The high instrument cluster OIL SERVICE INSPECTION display is located on the bottom of the cluster, to the left of center.

NOTE: Brake pad warning light should go out after replacement of brake pad thickness sensor. If warning light does not go out, turn ignition on, engine off, for 30-45 seconds. Warning light should go out. If the above procedure is not successful, connect vehicle to DIS tester, access Instrument Cluster/IKE, then "clear fault memory".

Start engine. Brake pad warning indicator will switch off.