Adjust Front Door
Further information is available .
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY DIMENSIONS .
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY DIMENSIONS .
- Open front door.
- Slacken screws (1) until the door can be moved at the front.
- Adjust the height (Z) of the front door.
- Adjust the width (Y) of the front door.
Check
- Check the gap dimensions between the front door and the adjacent body parts.
Result
» Gap dimensions do not correspond to specifications.
Measure
- Adjust front door.
- Tighten screws (1).
TIGHTENING TORQUES SPECIFICATION
| Front door to door hinge | |
| screw | Tightening torque 19 Nm |
Adjust the closing wedge
Further information is available .
Prerequisite
Screws on the closing wedge are loosened so far that the closing wedge can be moved.
NOTE:
TECHNICAL INFORMATION
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY DIMENSIONS .
The gap dimensions form the basis for these repair instructions and must be observed without fail.
For additional information see: BODY DIMENSIONS .
- Adjust the height of the locking wedge so that the door lock does not hit or rub.
- Shift the closing wedge sideways to adjust the gap dimension between the door and the side panel at the rear.
- Tighten screws (1).
TIGHTENING TORQUES SPECIFICATION
| Lock striker | |
| screw | Tightening torque 21 Nm |
Check