Installing the main bearing cap
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Replace screws (1) and (2).
Parts: Screws
- Tighten screws (1) and (2) on main bearing cap (3) crosswise.
TIGHTENING TORQUES SPECIFICATION
| Main bearing cap to crankcase | ||
|---|---|---|
| M10x85 Replace screws. |
1. Joining torque | 25 Nm |
| 3. Angle of rotation | 60° | |
| 4. Angle of rotation | 60° | |
Follow-up work
- Refer to INSTALLING THE OIL DEFLECTOR
- Refer to INSTALL THE OIL VACUUM PUMP
- Refer to INSTALL THE OIL SUMP .
- Refer to INSTALL THE ACOUSTIC COVER FOR THE OIL SUMP .
- Refer to TIGHTENING THE OIL DRAIN PLUG .
- Refer to TOPPING UP THE MOTOR OIL
- Refer to CHECK ENGINE OIL LEVEL .