LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> BMW >> 2017 >> 530i >> Repair and Diagnosis (Single Page) >> Quick Lookups >> Technical Bulletins >> Technical Service Bulletins >> Wiper/Washer Systems >> Low Washer Fluid Warning Light Is Illuminated When The Washer Fluid Tank Is Full (SI B61 23 15)

Low Washer Fluid Warning Light Is Illuminated When The Washer Fluid Tank Is Full (SI B61 23 15)

Publication date: 2020-11-04
Reference number: SI B61 23 15

LOW WASHER FLUID WARNING LIGHT IS ILLUMINATED WHEN THE WASHER FLUID TANK IS FULL

LOW WASHER FLUID WARNING LIGHT IS ILLUMINATED WHEN THE WASHER FLUID TANK IS FULL

SERVICE CAMPAIGN BULLETIN

Reference Number(s): SI B61 23 15, Date of Issue:  November 04, 2020
BMW: See The Chart Below

SERVICE INFORMATION

This Service Information Bulletin (Revision 2) replaces SI B61 23 15 dated April 2019. 

What's New  (Specific text highlighted):

MODEL

G00583240

SITUATION

The low washer fluid warning is illuminated even though the washer fluid reservoir is full. There are no faults stored in the system for the washer fluid level switch.

CAUSE

A non-approved washer fluid was used that is silicone-based. Silicone-based fluids are not compatible with the contactless capacitive level sensor. Fluids that contain a silicone additive are normally colored other than blue.

CORRECTION

Flush the washer fluid reservoir to remove the silicone-based fluid.

PROCEDURE

  1. Using ISTA, check for faults stored for the windshield washer system.

    Is a fault stored for the windshield washer level sensor? 

    NO-  Go to step 2.

    YES-  Diagnose the system using normal troubleshooting with ISTA.

  2. Check the windshield washer reservoir.

    Is the reservoir showing residue from colored fluids? 

    NO-  Diagnose the system using normal troubleshooting with ISTA. A fault code may be stored if an electrical fault occurs in the circuit.

    YES- 

    • Flush the reservoir using 250 ml of silicone remover concentrate mixed with approx. 1.5 quarts of tap water.
    • Leave the solution to work for 24 hours, then drain the solution.
    • Fill the reservoir with BMW windshield washer fluid.
NOTE: We recommend using "BMW Group approved" windshield washer fluid when servicing the vehicle, or when performing repairs on the windshield washer system.

PARTS INFORMATION

Obtain and confirm the part numbers for your specific vehicle by entering the chassis number in either ETK or AIR which takes into account specific equipment and/or options.

Part Number Description Quantity
83 19 2 406 220 BMW WWS Cold Weather Concentrate 35% 55 Gal As needed
83 19 2 361 205 BMW Windshield Washer Concentrate 1 Gal As needed
83 12 2 298 199 Silicone remover 1

WARRANTY INFORMATION

Not applicable.