Indirect System (Flat Tire Monitor)
CAUTION:
Do not initialize the system while snow chains are attached.
NOTE:
Each time a tire inflation pressure has been corrected or a wheel or tire has been changed, reset the system.
Reset:
- Start the engine.
- Lightly push button 1 on the turn indicator. See Fig 1.
- Lever the turn indicator up or down repeatedly until the tire monitor symbol appears in the display, accompanied by the word "RESET". See Fig 1.
- Press button 2 to confirm your choice of the Flat Tire Monitor.
- Press button 2 for approx. 5 seconds until the a check mark is shown next to the "RESET" display.
- Drive the vehicle.
The initialization is completed during driving, which can be interrupted at any time. When driving resumes, the initialization is continued automatically.
