Adjusting/replacing bump stops (530i 2017-2022, 530i xDrive 2017-2022, 530e PHEV 2018-2022, 530e xDrive PHEV 2018-2022, 540i 2017-2022, 540i xDrive 2017-2022, M550i xDrive 2018-2022)
The graphics are schematic representations and are to be applied to the relevant vehicle type.
Prerequisite: Lid must be correctly adjusted.
Following parts must not be damaged:
- (1) Bump stop
- (2) Catches
Remove adjusting buffer by pressing latch mechanisms back.
Screw adjusting buffer (1) until the pin (2) can be pulled out.
Slowly pull the pin (2) out approx. 15 mm.
Slowly close engine compartment lid.
The pin (2) is thus pushed into the adjusting buffer (1).
Raise engine compartment lid.
Unscrew the adjusting buffer (1) until it is flush with the upper edge of the pin (2).
