Installing/replacing the right rail pressure sensor
Prerequisite
Rail removed
- Screw in and tighten the rail pressure sensor (2) into the rail.TIGHTENING TORQUES SPECIFICATION
Rail pressure sensor to rail Rail pressure sensor
M10Tightening sequence 35 Nm - Unclamp the rail on the lug (1).
Follow-up work
- Refer to INSTALLING THE RIGHT HIGH-PRESSURE RAIL .
- Refer to INSTALL IGNITION COILS OF CYLINDER BANK 1 .
- Refer to INSTALLING CONTROL UNIT HOLDER FOR CYLINDERS 1 TO 4 .
- Refer to INSTALLING THE COVER OF THE RIGHT DME CONTROL UNIT .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .