Installing the oil coolant heat exchanger

• Do not use any metal-cutting tools.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clean sealing surface (1).
• Replace gaskets (1), (2), (3) and (4).

  Parts:  Seals

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the oil coolant heat exchanger on the full-flow oil filter.
• Tighten the screws (1), (2), (3), (4), (5) and (6).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Oil-to-water heat exchanger to full-flow oil filter
  M6	tightening torque	10 Nm

• Tighten the lid on the full-flow oil filter.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Oil filter cover to oil filter module
  O-ring lightly oiled.	Tightening torque	25 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE TRANSMISSION OIL COOLER .
• Refer to TIGHTENING THE OIL DRAIN PLUG .
• Refer to TIGHTENING THE OIL FILTER CAP .
• Refer to TOPPING UP THE MOTOR OIL .
• Refer to CONNECTING THE COOLANT LINES FOR THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING FRONT CROSS CONNECTION .
• Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
• Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
• Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
• Refer to INSTALLING THE THRUST FIELD .
• Refer to INSTALLING REAR UNDERBODY PROTECTION .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
• Refer to CHECKING ENGINE OIL LEVEL .