Installing the gear selector switch (GWS)

• Feed the cable into the cable clip at the gear selector switch (GWS) (2).
• Connect connector (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the gear selector switch (GWS) (2) in the center console (3).
• Tighten the screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Gear selector switch to support
  Oval-head screw Replace screws.	Tightening torque	3.3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up Work 

• Install the center console TRIM .
• Install the center ARMREST .
• Install the center armrest STORAGE COMPARTMENT .
• Connect all battery EARTH LEADS .
• Activate the 48 v ELECTRICAL SYSTEM .