Removing the right wiring harness section for the sensor system 2
Right wiring harness section for sensor system 2
NOTE:
RISK OF DAMAGE
Damage to wires when disconnecting connectors and plug connections.
Sheared wires can cause a short circuit.
Damage to wires when disconnecting connectors and plug connections.
Sheared wires can cause a short circuit.
- Do not pull on wires when disconnecting connectors and plug connections.
- Release the clamps (arrows).
- Unlock and detach the connector of the rail pressure sensor at the high-pressure rail.
- Unlock and detach the camshaft position sensor connector of the exhaust camshaft.
- Unlock and detach the connector of the hot film air mass meter.
- Unlock and detach the connector on the clean air pipe at the bottom.
- Unlock and detach the heating element connector for the air duct.
- Unlock and detach the exhaust turbocharger connector.
- Unlock and detach the high pressure pump connector.
- Unlock and detach the connector of the monitoring oxygen sensor.
- Unlock and detach the connector of the Lambda oxygen sensor.
- Unlock and detach the connectors from both solenoid valves for the camshaft adjustment.
- Unlock and detach the electric coolant pump connector.
- Remove the wiring harness section (1).
