Secure the wishbone on the top left and right on the swivel bearing
NOTE:
Perform the steps on the right and left side.
Secure the top wishbone on the swivel bearing
- Position upper wishbone (3) on the swivel bearing (4).
- Replace screws (2) and nuts (1).
Parts: Bolt, nut
- Insert screw (2).
The screw (2) must be positioned in the groove of the tappet of the upper wishbone (3).
(F) = driving direction
- Tighten nut (1).TIGHTENING TORQUES SPECIFICATION
Upper wishbone to swivel bearing M10
Replace screw and nut.Tightening torque
56 Nm
