Install the tension strut

• Replace clip nut (1).

  Parts:  Clip nut

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position tension strut (1) on front axle support.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install tension strut on swivel bearing.
• Replace nut (1).

  Parts:  Nut

• Tighten the nut (1), if necessary hold with a Torx key.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Tension strut to swivel bearing
  M16 Replace nut.	Joining torque  100 Nm Angle of rotation  90°

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the crash element (2).
• Replace the screw (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  Parts:  Screw

• Tighten screw (1) in NORMAL POSITION .
  TIGHTENING TORQUES SPECIFICATION
  
  

  Tension strut to front axle support
  M14 Replace flat nuts and screw. Tighten in normal position.	Joining torque  85 Nm Angle of rotation  180°

• Position wheel arch trim panel (2).
• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Wheel arch cover
  screw	Tightening torque	3 Nm
  Plastic nut	Tightening torque	2.6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  Install the brake ventilation duct

• Guide the brake ventilation duct (2) into the wheel arch cover.
• Tighten down screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up works 

• Refer to INSTALLING THE FRONT BOTTOM WHEEL ARCH COVER .
• Refer to MOUNTING THE WHEEL .