Installing the anti-roll bar
- Guide the anti-roll bar (3) in and position it.NOTE: Make sure that the retainer for the anti-roll bar and the holder upper sections are correctly positioned.
- Replace screws (1) and (2).
Parts: screw
- Tighten down screws (1) and (2).
Screws of different lengths. Note installation position!
Screws (1) = M12x89
Screws (2) = M12x50
TIGHTENING TORQUES SPECIFICATION
| Anti-roll bar to front axle support | ||
| M12 Replace screws. |
Joining torque | 100 Nm |
| Angle of rotation | 45° | |