Prepare New Part
Further information is available.
- Mark severance cuts on new part in accordance with severance cuts on vehicle and cut.
NOTE:
TECHNICAL INFORMATION
For additional information see: 41 00... Welding in reinforcement plates (sheet steel)
For additional information see: 41 00... Welding in reinforcement plates (sheet steel)
- Prepare reinforcement plates at separating cuts (1) and (2).
- Prepare for joining by welding in areas (3) and (4).
NOTE:
TECHNICAL INFORMATION
For additional information see: 41 00... Spot-weld bonding steel components
For additional information see: 41 00... Spot-weld bonding steel components
- In area (4), observe the procedure for the replacement of spot-welded adhesive joints for the series.