Installing The Rear Luggage Compartment Floor

Further information is available.

• Pre-clean bonding surfaces on vehicle and on new part with cleaning agent R2.
  CONSUMABLE - CLEANING AGENT DESCRIPTION (R2)
  
  

  Cleaning agent R2

  500 ml

  83190417324

• Clean bonding surfaces on vehicle and on new part with cleaning agent R1.
  CONSUMABLE - CLEANING AGENT DESCRIPTION (R1)
  
  

  Cleaning agent R1

  100 ml, Bottle

  83192211217

• Apply adhesive K5 to the bonding surfaces.
  ADHESIVE DESCRIPTION
  
  

  Body adhesive K5

  50 ml

  83192158654

• Install new part.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Rivet the new part in area (1) with blind rivets N3.
  CONSUMABLE - BLIND RIVET DESCRIPTION (N3)
  
  

  Blind rivet N3  Ø 4 mm; clamping area 1-3 mm

  83190301421

  Courtesy of BMW OF NORTH AMERICA, INC.

  Installing the EMC screw 

• Drill the hole with a diameter of 4.2 mm after the adhesive completely hardens.
• Screw in the EMC screw.
• Seal the EMC screw with the sealant.
  CONSUMABLE - SEALANT DESCRIPTION
  
  

  Sealant D1 (seam sealing)

  310ml

  83422409985

  NOTE: Perform the steps on the left and right side.
• Rivet the new part in area (1) with blind rivets N3.
  CONSUMABLE - BLIND RIVET DESCRIPTION
  
  

  Blind rivet N3  Ø 4 mm; clamping area 1-3 mm

  83190301421

• Once the adhesive has hardened, install 1 EMC screw in the area marked (2).
  CONSUMABLE - SCREW DESCRIPTION
  
  

  screw  EMC screw, SF Plus, M5x15

  83190301639

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to ACTIVATE HIGH-VOLTAGE SYSTEM .
• Refer to INSTALL FLAP IN RIGHT LUGGAGE COMPARTMENT TRIM PANEL .