Install Tail Panel Outer Section

Further information is available. 

• Pre-clean bonding surfaces on vehicle and on new part with cleaning agent R2.
  CONSUMABLE - CLEANING AGENT DESCRIPTION
  
  

  Cleaning agent R2

  500 ml

  83190417324

• Clean bonding surfaces on vehicle and on new part with cleaning agent R1.
  CONSUMABLE - CLEANING AGENT DESCRIPTION
  
  

  Cleaning agent R1

  100 ml, Bottle

  83192211217

• Apply adhesive K5 to bonding surfaces.
  ADHESIVE DESCRIPTION
  
  

  Body Adhesive K5

  195 ml

  83195A59935

• Install the new part and rivet in areas (1) to (5) with blind rivets N3.
  CONSUMABLE - BLIND RIVET DESCRIPTION
  
  

  Blind rivet N3	83190301421
  ø 4 mm; clamping area 1-3 mm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Rivet the tail cowling in the areas (1) and (2) with punch rivets N4.

  Area	Number
  1	total of 12
  2	total of 9

  CONSUMABLE - PUNCH RIVET DESCRIPTION
  
  

  Punch rivet N4	83192457307
  0 3 mm; 4 mm long

  Courtesy of BMW OF NORTH AMERICA, INC.

  Install EMC screw  

• Drill a 4.2 mm diameter hole after the adhesive has fully cured.
• Screw in the EMC screw.
• Seal the EMC screw with sealing compound.
  CONSUMABLE - SEALANT DESCRIPTION
  
  

  Sealant D1 (seam sealing)

  310 ml

  83422409985

  NOTE: TECHNICAL INFORMATION 
  Avoid contact of the escaped adhesive with the support for the bumper cover. Do not use any cleaning agents containing solvents.
• Press in the tail cowling in area (1) and remove the emerging adhesive.
• Attach the support for bumper cover.
• After the adhesive has hardened, install 3 EMC screws in the areas (2) shown.

  Consumable 

  Courtesy of BMW OF NORTH AMERICA, INC.

  screw	83190301639
  EMC screw, SF Plus, M5x15