Install the trim panel for the storage shelf
- Install the trim panel (2) for the storage shelf and insert the seat belt (3).
- Slightly raise the trim panel (2) for the storage shelf and connect and lock the underlying connector.
- Position the trim panel (2) correctly for the storage shelf and fasten the body-bound rivets (1).
- Check for correct fit of the trim panel for the storage shelf (1) on the ventilation grille (2).
NOTE:
The description is for one component only. The procedure is identical for all further components.
- Insert the belt feed trim (2).
- Clip in the cover (1) in direction of arrow.
- Feed in the end fitting (2) into the body.
- Replace screws (1).
Parts: Bolts
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| End fitting to body | ||
|---|---|---|
| M10 Replace screw. |
Tightening torque | 42 Nm |
- With SA416 roller sunblinds:
Tighten the screws (1) in the luggage compartment.
TIGHTENING TORQUES SPECIFICATION
| Roller sunblind | ||
|---|---|---|
| Tightening torque | 4 Nm | |
Follow-up Work
- Install the rear SEAT BENCH .
- Install the left and right backrest SIDE SECTION .
- Install both c-pillar TRIM PANELS .