DME FC 1C0102 Is Stored With No Other Related Faults (SI B12 07 18)

DME FC 1C0102 IS STORED WITH NO OTHER RELATED FAULTS

TECHNICAL SERVICE BULLETIN

SITUATION

The following fault has been stored in the Digital Motor electronics (DME) fault memory with no other engine oil pressure faults stored:

• 1C0102 - oil pressure control, plausibility, static: Pressure too low

This fault will not cause a customer complaint or a Check Control Message (CCM). The fault is typically identified during unrelated diagnostics.

CAUSE

Software error in the Digital Motor Electronics (DME) may cause the fault code to be erroneously stored. Only the following integration levels contain the software error.

• 17-11-5xx
• 18-03-5xx

CORRECTION

This fault should be ignored until the release of ISTA 4.12.1x.  After the release of ISTA 4.12.1x  , the vehicle should be programmed.

PROCEDURE

Prior to the release if ISTA 4.12.1x 

1. If no other oil pressure faults are present the fault should be ignored.

After the release of ISTA 4.12.1x: 

1. Perform diagnosis with the latest version of ISTA Next.
2. Program the vehicle with ISTA 4.12.1x  or higher

Note that ISTA Next will automatically reprogram and code all programmable control modules that do not have the latest software.

Always connect a BMW-approved battery charger/power supply ( SI B04 23 10  )  .

For information on programming and coding with ISTA, refer to CenterNet / TIS / Technical Documentation / Programming and Diagnostics / Programming Documentation.

WARRANTY INFORMATION

Covered under the terms of the BMW New Vehicle Limited Warranty for Passenger Cars and Light Trucks or the BMW Certified Pre-Owned Program.

Defect Code:

1141004500

Labor Operation:	Labor Allowance:	Description:
00 00 006	Refer to KSD2	Performing "vehicle test" (with vehicle diagnosis system - checking faults) (Main work)
Or:
00 00 556	Refer to KSD2	Performing "vehicle test" (with vehicle diagnosis system - checking faults) (Plus work)
And:
61 21 528	Refer to KSD2	Connect an approved battery charger/power supply (indicated in KSD2 as Charging battery)
And:
61 00 730	Refer to KSD2	Program/encode control unit(s)

If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556 instead of 00 00 006.

Refer to KSD2/AIR for the corresponding flat rate unit (FRU) allowances.

During the same workshop visit, if a vehicle also requires another Technical Campaign or repair that also includes programming and encoding the control units, the programming procedure may only be invoiced one time.