Install front brake pads (17-inch Low brake)

Observe direction of rotation of brake pads.
The arrow (1) must always point upwards towards the bleed valve.

Courtesy of BMW OF NORTH AMERICA, INC.
Remove the protective film of the adhesive layer (1) at the brake pads.
The adhesive layer (1) must not be taped.

Courtesy of BMW OF NORTH AMERICA, INC.
Position brake pads (1) completely onto hammerhead guides first (2).
Press in the brake pads (1) into the brake caliper in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.
Check fit of slide plate (1) and correct if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.
Remove the special tool (cable tie) 2 413 317 .
Install brake caliper (1) in arrow direction.
Replace screws.
Parts: screw

Tighten down screws (2).

TIGHTENING TORQUES SPECIFICATION

Brake caliper/brake anchor plate at front swivel bearing
M12 Replace screw.	Tightening torque	110 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Replace the carriage spring.
Parts: Carriage spring

The carriage spring must be replaced every time it is disassembled.
Insert carriage springs in arrow direction (from the center of vehicle to the vehicle exterior).
The carriage spring must engage with the locking mechanism (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Check carriage spring (1) for correct latching into stop.

Courtesy of BMW OF NORTH AMERICA, INC.