Installing the front brake disc chamber (high brake)

• If an arrow 1 is engraved on the brake disk, it must point in the driving direction!

  In this case, the left and right brake discs are different!

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clean contact surface of wheel hub thoroughly and remove any traces of rust if necessary.

  Irregularities in the contact surface can cause distortion in the brake disc!

• Mount brake disc (2).
• Position and tighten the screw (1).
• Replace the screw (1).

  Parts:  Screw

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  Brake disc to front wheel hub
  M8 Replace screw.	Tightening torque	16 Nm

• Install the brake caliper in the direction of the arrow.
• Insert screws (1) and tighten them.
• Replace screws (1).

  Parts:  screw

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Grease BRAKE PADS , brake anchor plate and brake caliper with brake pad paste (brake high).
• Install FRONT PADS  (high brake).
• Install the front brake pad WEAR SENSOR .
• Install the front left and right WHEELS .
• COMMISSION OR BEDD IN new brake pads and discs (high brake).