Remount the holder of the hydraulic unit and remount the brake lines

Remount hydraulic unit holder 

• Release screws (1) and remove the holder (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install holder (2).
• Insert screws (1) and tighten them.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Hydraulic control unit to holder
  M6 Replace screws.	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  Remount brake lines at the hydraulic unit 

• Release all brake lines (1) and completely remove with the holders.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fit all brake lines (1) completely with the holders.
• Tighten all brake lines (1).

Courtesy of BMW OF NORTH AMERICA, INC.