Installing the housing cover
- Position the housing cover (2) on the rear axle differential.
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Lid to rear axle differential | ||
| M12 | Tightening torque | 140 Nm |
Follow-up work
- Replace the left and right drive flange radial shaft SEALING RING .
- For reusing: check the output shaft on the left and right and replacing the SNAP RINGS .
- Install rear AXLE DIFFERENTIAL .
- Fasten the rear axle differential right and left OUTPUT SHAFTS .
- Check/top up the rear axle differential OIL LEVEL .
- Secure the rear axle differential PROPELLER SHAFT .
- Install the rear HEAT SHIELD .
- Install EXHAUST SYSTEM
- Install the left and right camber control arm COVER .