Observe the installation position of the rubber mount in the rear axle support
NOTE:
TECHNICAL INFORMATION
The installation position of the rubber mount has been changed.
Please note correct installation position (see graphic).
The installation position of the rubber mount has been changed.
Please note correct installation position (see graphic).
- Observe the installation position of the rubber mount (1) in the rear axle support (2).
(F) = driving direction
- Align the elongated hole of the rubber mount (1) correctly in the transverse direction of vehicle.
A deviation of maximum ± 5° is permitted.
- Make sure that the arrow on the rubber mount (1) points upwards.
- Add a mark on the outer area of the rubber mount (1) for checking before the installation.

