Preparing the special tool
WARNING:
Motor vehicle may slip off the vehicle hoist where components are supported.
Danger! Life-threatening injuries!
Danger! Life-threatening injuries!
- Secure the vehicle hoist against lowering and lifting.
Preliminary work
- Remove the rear left and right WHEELS .
- Remove the tank COVERS .
- Remove EXHAUST SYSTEM
- If installed: remove the torsion struts MOUNTING BLOCK .
- Remove the left and right camber control arm COVER .
- Remove the rear HEAT SHIELD .
- Release the rear axle differential PROPELLER SHAFT .
- Disconnect the rear ride height sensor PLUG CONNECTION .
- Detach right and left CABLES .
- Disconnect the left and the right PLUG CONNECTIONS .
- If installed: release the CABLE .
- If installed: release the WIRING HARNESS .
- Detach rear left and right BRAKE CALIPER .
WARNING:
Motor vehicle may slip off the vehicle hoist if the weight is distributed unevenly.
Danger! Life-threatening injuries!
Danger! Life-threatening injuries!
- Ensure there is a specific weight compensation on the motor vehicle.
NOTE:
TECHNICAL INFORMATION
In a profile rail pair, two profile rails are connected to one another by gearing.
In a profile rail pair, two profile rails are connected to one another by gearing.
