Raise front axle support
If installed on left: Position spray guard
- Position spray guard (1) on output shaft (2).
- Lift the front axle support (1) and position it on the side member (2).
If installed on left: Install spray guard
- Position spray guard (2) on front axle support.
- Position screws (1).
- Tighten down screw (1).TIGHTENING TORQUES SPECIFICATION
Splash guard on front axle support M6 tightening torque 8 Nm - Tighten screws (1) of spray guard (2).
TIGHTENING TORQUES SPECIFICATION
| Splash guard on front axle support | ||
|---|---|---|
| M6 | tightening torque | 8 Nm |



