Installing the crankshaft sensor
- Feed in and install the crankshaft sensor (3).
- Tighten down screw (2).
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
- With automatic transmission:
Insert and install the holder (2).
Make sure that the holder (2) is installed correctly in the guide (3).
Position transmission oil line (4) on holder (2).
Secure clamps (1).
- With automatic transmission:
- Tighten down screw (3).
TIGHTENING TORQUES SPECIFICATION
| Holder on end cover | ||
|---|---|---|
| M6X16 | Tightening torque | 8 Nm |
- Insert and position the holders (2).
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Holder for transmission oil line | ||
|---|---|---|
| Screw | Tightening torque | 4 Nm |
- Guide in and position manifold support (2).
- Hand-tighten the bolts (1).
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Manifold bracket on intake plenum | ||
|---|---|---|
| M6x25 | tightening torque | 8 Nm |
- Tighten screws (1) at the manifold brackets (2).
TIGHTENING TORQUES SPECIFICATION
| Manifold bracket to crankcase | ||
|---|---|---|
| M6x16 | tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING REAR UNDERBODY PROTECTION .
- Refer to INSTALLING ACOUSTIC COVER .