Installing the camshaft position sensor of the intake camshaft on the left
- Replace and lubricate the sealing ring on camshaft sensor.
Parts: Sealing ring
- Install the camshaft position sensor (3) of the intake camshaft on the left.
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Camshaft position sensor to cylinder head cover | ||
| Torx screw M6 | Tightening torque | 8 Nm |
- Pin up connector (1) and lock audibly.
Follow-up work
- Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .