Installing starter motor
- Insert and install the starter motor (2).
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Starter motor to crankcase M8x60 Tightening torque 19 Nm - Thread in and position the acoustic cover (1).
- Secure all expanding rivets (1).
- Connect and lock the connector (1).
- Make sure the connector (1) engages audibly.
- Insert and install the positive battery cable (3).
- Secure positive battery cable (3) at the clamp (4).
- Tighten the nut (2) hand-tight.CAUTION: Improper routing of the positive battery cable.
Risk of short circuits!- Route the positive battery cable without abrasions and do not trap.
- Correctly attach the positive battery cable (1) to the anti-twist lock (2).
- Tighten nut (3).TIGHTENING TORQUES SPECIFICATION
Battery positive lead to starter M8 Tightening torque 13.5 Nm
Follow-up work
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to CONNECTING NEGATIVE BATTERY CABLE .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .




