Install right wiring harness section for sensor system 2
Right wiring harness section for sensor system 2
- Guide in the wiring harness section (1) and install.
- Connect and lock the connector of the rail pressure sensor on the high pressure rail.
- Connect and lock the connector of the camshaft position sensor of the exhaust camshaft.
- Connect and lock the connector of the hot film air mass meter.
- Plug the connector into the lower clean air pipe and lock.
- Connect and lock plug of the heating element for the air routing.
- Connect and lock the connector for the exhaust turbocharger.
- Connect and lock the connector of the high pressure pump.
- Connect the connector of the monitoring oxygen sensor and lock.
- Connect and lock the connector of the Lambda oxygen sensor.
- Connect and lock the connector from both solenoid valves for the camshaft adjustment.
- Connect and lock the connector of the electric coolant pump.
- Make sure that all connectors engage audibly.
- Secure the clamps (arrows).
