Installing transmission wiring harness
Transmission wiring harness
- Route the wiring harness according to the graphic RB12 01090 and fasten.
- Connect the connector (1) on the transmission and audibly lock.
- Connect the ground cable and tighten the nut (2).
TIGHTENING TORQUES SPECIFICATION
| Ground cable to transmission | ||
| Tightening torque | 8 Nm | |
- Connect the connector (3) on the starter motor and audibly lock.
- Lock the wiring harness (1) and fasten to the clamps.
- Connect the connector (1), it should lock audibly.
- Fasten the wiring harness (2) to the clamps.
- Connect the connector (3) to the air conditioning compressor and lock audibly.
Follow-up work
- Refer to INSTALLING THE LEFT-HAND CHARGE AIR COOLER .
- Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
- Refer to CONNECTING THE LEFT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING THE COOLANT HOSE TO THE AUXILIARY COOLANT PUMP .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE THRUST FIELD .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP .
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .



