Encode/program control unit(s)
Prerequisite
The control unit was replaced.
NOTE:
TECHNICAL INFORMATION
Use the most recent software version to prevent faults during programing/encoding.
The battery voltage must not fall below 13.0 V during programing.
Use only chargers for a low volt-vehicle electrical system that are recommended by BMW.
Use the most recent software version to prevent faults during programing/encoding.
The battery voltage must not fall below 13.0 V during programing.
Use only chargers for a low volt-vehicle electrical system that are recommended by BMW.
NOTE:
TECHNICAL INFORMATION
No high-voltage switch off is required in electric vehicles or hybrid vehicles for programing/encoding.
The high-voltage system will be automatically switched off by the programing system.
Exception:
BMW 101: Note Product and Measures Management Aftersales measure 55176388.
No high-voltage switch off is required in electric vehicles or hybrid vehicles for programing/encoding.
The high-voltage system will be automatically switched off by the programing system.
Exception:
BMW 101: Note Product and Measures Management Aftersales measure 55176388.
- Connect the battery charger to the vehicle (activity not included in the flat rate unit).
- Connect the programing system with the vehicle.
- Determine the action plan.
- Accept and fully process the measures plan.
- If applicable, connect the workshop system to the vehicle, depending on the reworking list.
- Carry out vehicle test.
- Delete the fault memory.
- The information about programing the workshop system and the corresponding notes in the user documentation must be observed.
- Wait until programing/encoding has been completed.
- Disconnect the programing system from the vehicle.
- Disconnect the battery charger from the vehicle.