Installing washer fluid reservoir
- Connect all connectors (1).
- Clip the cable into the washer fluid reservoir (3) (arrows).
- Connect hose line (2).
- Feed in the washer fluid reservoir (1) to the back in the brackets (2).
- Tighten down screw (2).TIGHTENING TORQUES SPECIFICATION
Washer fluid reservoir Tightening torque 8 Nm - Connect the hose pipe (1) of the headlight cleaning system.
- Clip hose pipe (1) into the washer fluid reservoir (3).
- Clip the filler channel (1) downwards into the washer fluid reservoir (2).
Follow-up Work
- Install the inner side panel AIR DUCT .
- Install the side panel TRIM .
- Install the rear section of the front wheel ARCH COVER .
- Install bonnet SEAL FIXTURE .
- Install the washer fluid RESERVOIR LID .
- Install the rear right engine compartment COVER .
- Install the top right engine compartment COVER .
- Install the front right WHEEL .
- Reset the TIRE PRESSURE MONITOR .



