Installing coolant pumps
NOTE:
TECHNICAL INFORMATION
The sealing surfaces must be free of oil, grease and cleaning agents.
The sealing surfaces must be free of oil, grease and cleaning agents.
- Make sure that the fitting sleeve is in the crankcase.
- Clean sealing surface.
- Insert the coolant pump (1).
- Connect the connector (1) to the coolant pump (2) and lock audibly.
- Position the coolant pump (1) on the crankcase.
- Tighten the screw (1) (M6x90).
TIGHTENING TORQUES SPECIFICATION
| Coolant pump to crankcase | ||
|---|---|---|
| M6 | tightening torque | 10 Nm |
- Tighten the screw (2) (M6x70).
TIGHTENING TORQUES SPECIFICATION
| Coolant pump to crankcase | ||
|---|---|---|
| M6 | tightening torque | 10 Nm |
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Coolant pump to crankcase | ||
|---|---|---|
| M6 | tightening torque | 10 Nm |
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Coolant pump to crankcase | ||
|---|---|---|
| M6 | tightening torque | 10 Nm |
- Pin up connector (1) and lock audibly.
- Connect and audibly lock coolant hose (2).
- Connect and audibly lock coolant hose (3).
- Connect the coolant line (2) to the coolant pump.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Coolant line to cylinder head | ||
|---|---|---|
| M6 | tightening torque | 8 Nm |
- Connect the coolant line (2) to the coolant pump.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Coolant line on coolant pump | ||
|---|---|---|
| Screw | tightening torque | 8 Nm |
Follow-up work
- Refer to PUTTING ON THE DRIVE BELT .
- Refer to REMOVING SPECIAL TOOL ON BELT TENSIONER .
- Refer to SECURING THE COOLANT EXPANSION TANK IN THE HOLDERS .
- Refer to INSTALLING THE LEFT-HAND CHARGE AIR COOLER .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to FILLING THE COOLING SYSTEM WITH THE VACUUM FILLING UNIT .
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .
- Refer to INSTALLING ACOUSTIC COVER .