Install heat management module

Courtesy of BMW OF NORTH AMERICA, INC.

• Clean the sealing surfaces (1) on the crankcase with the special tool 0 495 102 (11 4 470). 
• Replace the sealing rings (1).

  Parts:  Sealing rings

• Feed in the sealing rings (1) at the heat management module (2) and install.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Correctly position the heat management module (2).
• Hand-tighten the bolts (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1) on the heat management module (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  Heat exchange module to crankcase
  M6	Tightening torque	9 Nm

  NOTE: RISK OF DAMAGE 
  Improper routing of cables and wiring harnesses. 
  Trapped, crushed or damaged cables may cause short circuits and malfunctions. 

  • Route all cables without abrasions, do not trap and crush.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and position wiring harness section (4) for sensor system 1. 
• Secure clamps (3).
• Connect connectors (1) to (2) and lock.

  Make sure you can hear the connectors (1) and (2) engage.

• Guide in and position the coolant line (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Lock the coolant line (1).

  The coolant line (1) must audibly engage.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE COMPLETE FULL-FLOW OIL FILTER .
• Refer to INSTALLING THE THERMOSTAT ON THE TRANSMISSION OIL LINES .
• Refer to TIGHTENING THE OIL FILTER CAP .
• Refer to TOPPING UP THE MOTOR OIL .
• Refer to INSTALLING INTAKE PLENUM .
• Refer to INSTALLING THE TANK VENT VALVE .
• Refer to INSTALLING CONTROL UNIT BRACKET .
• Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
• Refer to INSTALLING THE DME CONTROL UNIT .
• Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING RESONATOR .
• Refer to CONNECTING NEGATIVE BATTERY CABLE .
• Refer to FILLING AND VENT THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to FILLING AND VENT THE LOW-TEMPERATURE COOLANT CIRCUIT .
• Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
• Refer to CHECKING ENGINE OIL LEVEL .
• Refer to INSTALLING ACOUSTIC COVER AT REAR
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
• Refer to INSTALLING THE REAR THRUST FIELD .
• Refer to INSTALLING REAR UNDERBODY PROTECTION .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
• Refer to TAKE HOOD OUT OF THE SERVICE POSITION .