Remove intermediate pipe
Intermediate pipe
NOTE:
DANGER
High voltage.
Mortal hazard through electric shock!
High voltage.
Mortal hazard through electric shock!
- Before removal, disconnect all components from the voltage supply: Switch off lighting system and ignition.
- For additional information see:
63 99... SAFETY INSTRUCTIONS FOR HANDLING BULBS/LIGHT SOURCES (EXTERIOR LIGHTING)
Preliminary work
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
CAUTION:
Heavy component.
Heavy components can lead to injury or damage.
Heavy components can lead to injury or damage.
- Remove and install heavy components with the aid of another person/other persons.
CAUTION:
Shavings resulting from sawing or grinding components.
Injury hazard!
Injury hazard!
- Conduct all work in appropriate personal protective equipment only.
- Wear safety goggles and hand protection.
- If the separation point is not marked by the grain in the pipe: Determine the separation point by the length of the pipe on the new component.
- Mark the separation point on the component being replaceed.
- Cut through the component to be replaced at the marked point with a suitable tool.
- Unscrew the bolt (1) from the rear axle support.
- Feed the intermediate pipe (1) out and remove.
