Installing the two pressure lines at the top
- Version with S1DFA:
Replace sealing rings (1).
Parts: Sealing ring
Position sealing rings (1).
NOTE: For a better overview the removed condition is shown here. - Version with S1DFA:
Position sealing rings (3).
Position the pressure line at the top of cylinder bank 2 (2) in mounting eye (5) and tilt it in the arrow direction towards the center of vehicle.
Position the pressure line at the top of cylinder bank 1 (1) in mounting eye (4) and tilt it in the arrow direction towards the center of vehicle.
- Check the position of sealing rings (1) and, if necessary, correct it.
No sealing ring must have slipped.
- Version with S1DFA:
Tighten screws in areas (1).
Tightening torques
Pressure line lug to the lateral side of the heat shield M6x16 screw Tightening torque 10 Nm
