Install coolant temperature sensor
- Insert and install the coolant temperature sensor (2).
- Tighten the coolant temperature sensor (2).
TIGHTENING TORQUES SPECIFICATION
| Coolant temperature sensor at cylinder head | ||
| Sensor | Tightening torque | 18 Nm |
- Connect and lock the connector (1).
- Make sure the connector (1) engages audibly.
- Loosen sealing cap (1).
- Equate coolant level to the maximum marking (1) in the coolant expansion tank for maximum temperature (2).
- Close sealing cap (1).
- Close the sealing cap (1) until the arrows are flush.
Follow-up work
- Refer to INSTALL INTAKE PLENUM .
- Refer to INSTALLING THE TANK VENT VALVE .
- Refer to CONNECT THE COOLANT LINES FOR THE LOW-TEMPERATURE COOLANT CIRCUIT .
- Refer to INSTALL CONTROL UNIT BRACKET .
- Refer to INSTALL THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to INSTALLING THE DME CONTROL UNIT .
- Refer to INSTALL RESONATOR .
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .
- Refer to CHECKING LOW-TEMPERATURE COOLING SYSTEM FOR WATERTIGHTNESS .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALL THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALL ACOUSTIC COVER .
- Refer to INSTALL THE FRONT HOOD SEAL AT THE REAR .