Install temperature sensor on the crankcase

• Feed in and install the temperature sensor (3) in the crankcase.
• Tighten down screw (2).

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1) and lock.

  The connector (1) must engage audibly.

Follow-up works 

• Refer to INSTALL INTAKE PLENUM .
• Refer to INSTALLING THE TANK VENT VALVE .
• Refer to INSTALL CONTROL UNIT BRACKET .
• Refer to INSTALL THE INTEGRATED POWER SUPPLY MODULE (PDM) .
• Refer to INSTALLING THE DME CONTROL UNIT .
• Refer to INSTALL RESONATOR .
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
• Refer to FILL AND VENT THE LOW-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING ACOUSTIC COVER AT REAR
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to INSTALL THE FRONT HOOD SEAL AT THE REAR .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
• Refer to INSTALL THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
• Refer to TAKE HOOD OUT OF THE SERVICE POSITION .