Installing the hydraulic valve for the oil pressure control

• Check the O-ring (1) for damage.
• If necessary, replace the hydraulic valve.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the hydraulic valve (2).
• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Hydraulic valve to crankcase
  M6 x 18	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connector (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the transmission bolt (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE TRANSMISSION OIL COOLER .
• Refer to CONNECTING THE COOLANT LINES FOR THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING FRONT CROSS CONNECTION .
• Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
• Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP .
• Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
• Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
• Refer to INSTALLING THE THRUST FIELD .
• Refer to INSTALLING REAR UNDERBODY PROTECTION .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .