Install intake camshaft of bank 1
- Plastic rings (1) are maintenance free and do not need to be replaced.
- Check plastic rings for damage, replace if necessary.NOTE: TECHNICAL INFORMATION
The rocker arms may slip slightly when the camshaft is positioned. Make sure rocker arms are correctly positioned on the hydraulic valve clearance compensating elements and on valves. - Position intake camshaft.
- When screwing the camshafts, make sure the valves have free movement.
- Position guide bearing shells according to marks (E1) to (E5).
- Join the screws of the guide bearings with position numbers (1) and (4) in multiple steps by one half turn at a time until flush.
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Intake/exhaust camshaft M6 Tightening torque 10 Nm - Tighten down screws (4).TIGHTENING TORQUES SPECIFICATION
Intake/exhaust camshaft M6 Tightening torque 10 Nm - All intermediate levers (3) must rest correctly on the idler pulley (1) and on the camshaft (4).
- All intermediate levers (3) must rest correctly on the idler pulley (2) and on the eccentric shaft (5).
