Screwing the flywheel

NOTE: TECHNICAL INFORMATION
Replace microencapsulated screws.
The screw lining must be completed within 15 minutes, as the hardening begins after this time period. Microencapsulated screws must not be retightened.

Screw the bolts in with the sequence (1) to (9).

TIGHTENING TORQUES SPECIFICATION

Flywheel to crankshaft automatic
M12x1.5 Replace screws.	Tightening torque	105 Nm

Fig 1: Flywheel Screws Tightening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING AUTOMATIC TRANSMISSION (ALL-WHEEL DRIVE VEHICLE) (GA8HP75Z) .