Replacing front crankshaft seal
- Removing the front crankshaft seal
- Drive in the crankshaft seal (1) in the marked area with a punch to approx. 1 cm deep.
- Lever out the crankshaft sealing ring (1) with the special tool 2 298 505.
- Make sure that the sealing surface on the crankcase is not
scratched.
- Installing the front crankshaft seal
- Prepare special tool 0 496 130 (11 8 803).
- Clean the special tool 0 496 128 (11 8 801) from the set of special tools 0 496 127 (11 8 800) and coat it with motor oil.
- Secure special tool 0 496 128 (11 8 801) to the crankshaft using special tool 0 496 129 (11 8 802) from the set of special tools 0 496 127 (11 8 800).
NOTE:
RISK OF DAMAGE
Radial shaft seal damage.
Taping the sealing lip (inner) and applying oil to the radial shaft seal will lead to its destruction.
Radial shaft seal damage.
Taping the sealing lip (inner) and applying oil to the radial shaft seal will lead to its destruction.
- Do not tap the sealing lip (inner) of the radial shaft seal.
- Do not apply oil to the radial shaft seal.
- Install the radial shaft seal dry.
- Carefully slide the crankshaft sealing ring (1) straight in a rotational movement onto the special tool 0 496 128 (11 8 801) from the set of special tools 0 496 127 (11 8 800) until the crankshaft sealing ring (1) is positioned flush against the crankcase.
- Mount the special tool 0 496 130 (11 8 803) on special tool 0 496 128 (11 8 801) of the set of special tools 0 496 127 (11 8 800) in arrow direction.
- Refer to Screw in the special tool (sleeve) 0 496 130 (11 8 803)using the special tool 0 496 131 (11 8 804) from the set of special tools 0 496 127 (11 8 800) and a suitable tool until the sleeve is positioned flush against the crankcase (1).
- Refer to Release the special tool 0 496 131 (11 8 804)and remove .
- Refer to Feed out and remove the special tool 0 496 130 (11 8 803)on the special tool 0 496 128 (11 8 801)of the set of special tools 0 496 127 (11 8 800)in arrow direction .
- Release the special tool 0 496 129 (11 8 802).
- Refer to Feed out and remove the special tool 0 496 128 (11 8 801) and 0 496 129 (11 8 802)on the crankshaft.
- Check the crankshaft sealing ring (1) for correct installation on the crankcase (2).