Installing the vibration damper

Courtesy of BMW OF NORTH AMERICA, INC.

Check 

• Check if the special tool 0 496 595 (11 6 130)  is installed correctly.

Result 

» Special tool 0 496 595 (11 6 130)  not fitted.

Measure

• Install special tool 0 496 595 (11 6 130),  remove vibration damper.

• Install vibration damper (2) from the top and position correctly.
• Tighten the screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Vibration damper to crankshaft
  M10 x 65 Replace screws.	Joining torque  Angle of rotation	40 Nm 120°

  Courtesy of BMW OF NORTH AMERICA, INC.

• Remove special tool 0 496 595 (11 6 130). 

Follow-up work 

• Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
• Refer to INSTALL FAN COWL .
• Refer to INSTALL THE REAR TOP CROSS CONNECTION .
• Refer to INSTALL FRONT CROSS CONNECTION .
• Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
• Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP
• Refer to INSTALLING STARTER MOTOR .
• Refer to INSTALL THE THRUST FIELD .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
• Refer to INSTALL THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
• Refer to CONNECTING NEGATIVE BATTERY CABLE .