11 00 598 Remove and install the engine on the front axle (M550i xDrive 2018-2019): Notes
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
CAUTION:
Component with heavy weight.
Injury hazard!
Injury hazard!
- Note component's center of gravity.
- Support component using a jack.
- Secure component against falling off the jack.
NOTE:
RISK OF DAMAGE
Engine damage due to missing motor oil.
Missing motor oil following repairs to the components in the oil circuit or replacement of the engine can lead to damage to the engine.
Engine damage due to missing motor oil.
Missing motor oil following repairs to the components in the oil circuit or replacement of the engine can lead to damage to the engine.
- Following repairs to components in the oil circuit or replacement of the engine, do not start the engine without observing the repair notes.
- It is imperative that you observe the repair notes following repairs to components in the oil circuit or replacement of the engine.
- For additional information, see the REPAIR NOTES .
Preliminary work:
- Refer to IF INSTALLED: REMOVING THE HUB CAP .
- Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
- Refer to REMOVING OUTPUT SHAFT .
- Refer to REMOVING THE RUBBER COVER OF THE CONVERTER BOLTING .
- Refer to RELEASING CONVERTER BOLTING .
- Refer to SECURING THE TORQUE CONVERTER
- Refer to DISCONNECTING THE CONNECTOR FROM VTG CONTROL UNIT .
- Refer to DISCONNECTING THE CONNECTOR FROM THE SEALING SLEEVE .
- Refer to UNDO REMAINING TORX SCREWS
- Refer to DISCONNECTING TRANSMISSION FROM ENGINE .
- Refer to LOOSENING THE SCREW CONNECTION ON THE LEFT OF THE ENGINE MOUNT .
- Refer to RELEASING THE ENGINE MOUNT .