Lowering the engine and detaching the engine bridge
- Turn the special tool (spindle) 2 361 506 (00 6 103) to lower the engine until it is positioned completely flat on the engine mounts.
- Remove the engine bridge with the help from another person.
- Tighten screws (1) on the left and right.TIGHTENING TORQUES SPECIFICATION
Top rear connection to body Torx screw M8x30 tightening torque 19 Nm Installing the lateral hood seals
NOTE: Perform the steps on the right and left side. - Position the lateral hood seal (2) at the shock tower.
- Secure the rivet (1).
