Lowering the engine and remove the engine bridge
- Turn the special tool (spindle) 2 361 506 (00 6 103) to lower the engine until it is positioned completely flat on the engine mounts.
- Remove the engine bridge with the help from another person.
- Tighten screws (1) on left and right.TIGHTENING TORQUES SPECIFICATION
Top rear connection to body Torx screw M8x30 Tightening torque 19 Nm Install side bonnet seals
NOTE: Perform the operations on the left and right side. - Position the side bonnet seal (2) on the spring strut dome.
- Secure the rivet (1).


