Removing the intake plenum

WARNING: working on 12 V electrical system.
Risk of short circuits! Risk of fire!

Make sure that there is no charger connected to the jump start terminal in the engine compartment.
Detach battery ground lead from battery.
For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.

NOTE: RISK OF DAMAGE
Damage to battery terminal, the safety battery terminal or the intelligent battery sensor (IBS).
Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

Detach battery terminal from battery pole by carefully shifting to and fro. Do not pry off using a tool.

Preliminary work

Refer to BRINGING FRONT COMPARTMENT LID IN THE SERVICE POSITION .
Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
Refer to REMOVING THE SEAL FOR THE HOOD REAR .
Refer to REMOVING THE ACOUSTIC COVER .
Refer to REMOVING ACOUSTIC COVER AT REAR .
Refer to REMOVING THE DME CONTROL UNIT .
Refer to REMOVING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
Refer to REMOVING CONTROL UNIT BRACKET .
Refer to REMOVING RESONATOR .
Refer to REMOVING TANK VENT VALVE .
Refer to REMOVING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
Refer to REMOVING THE UNDERBODY PROTECTION OF THE STEERING GEAR AND THRUST FIELD RESPECTIVELY .
Refer to DRAINING THE COOLANT FROM THE LOW-TEMPERATURE COOLING SYSTEM .

NOTE: RISK OF DAMAGE
Damage to wires when disconnecting connectors and plug connections.
Sheared wires can cause a short circuit.

Do not pull on wires when disconnecting connectors and plug connections.

NOTE: TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.

Unlock plug connection (1) and disconnect.
Unlock plug connection (2) and disconnect.
Unlock and loosen clamp (3).

Courtesy of BMW OF NORTH AMERICA, INC.
Remove screws (arrows).
Feed out charge air line (1) and place to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screw (1).
Guide tank ventilation line (2) out of clamp (3) and remove it.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
The tension rod screws and mounting bolts from the connecting neck on the intake plenum are not allowed to be opened.

Do not release screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Release the clamping collar (1) with the special tool 0 495 794 (17 2 050)
Guide out the coolant hose (2) and remove it.
Catch and dispose of escaping coolant.
Unlock the locks (arrows).
Feed out the wiring harness section (3) for the sensor system 2 and set it aside.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock lock (1).
Thread out holder (2) and set aside.

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) and disconnect.
Loosen screw (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock the locks (arrows).
Feed out the wiring harness section (1) for the injectors and ignition coils and put to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen clamp (1).
Feed out the wiring harness section (2) for the injectors and ignition coils and put to one side.