11 65 CHARGER WITH CONTROL (530e xDrive PHEV 2018-2020)
11 65 TIGHTENING TORQUE OVERVIEW
| Electrical controller drive to exhaust turbocharger | ||
| M4 Disassemble all installation aids! |
Tightening torque | 3 ± 0.5 Nm |
| Electrical controller drive to exhaust turbocharger | ||
| Replace screws. Tighten screws crosswise. |
Tightening torque | 3 ± 0.5 Nm |
| Exhaust turbocharger support to crankcase | ||
| M8 x 20 Replace screws. |
Tightening torque | 19 Nm |
| Exhaust turbocharger to support | ||
| M8 x 25 Replace screw. |
Tightening torque | 19 Nm |
| Heat shield to cylinder head | ||
| M8 x 12 | Tightening torque | 19 Nm |
| Lock nut to control rod | ||
| Use the second open-end wrench for counter support! Use the special tool (gauge) to align the control rod! |
Tightening torque | 7.5 ± 1.2 Nm |
| Trim strip at the cylinder head | ||
| M7 x 27 Replace screws. Tighten from the inside to the outside. |
1. Assembly torque | 10 Nm |
| 2. Assembly torque | 16 Nm | |
| 3. Final torque | 16 Nm | |
| U bolt to special tool 2 919 (446) | ||
| The tightening torque must be observed! Risk of damage to the exhaust manifold! | Tightening torque | 1 Nm |
| Wastegate linkage to wastegate valve controller | ||
| M6 | Tightening torque | 5 Nm |