Evaluating Test Results
Evaluating the battery test results for the Warranty and Service Tests
| Battery Test Result | Measure |
|---|---|
| Battery good | No measure on the battery |
| Battery good - recharge | Charge battery. Refer to BATTERY, CHARGING . If necessary, search for the cause of the discharging |
| Perform a current draw test | Perform a current draw test. Refer to CURRENT DRAW TEST . Charge the battery completely and test again. Refer to BATTERY, CHARGING . |
| Replace the battery. | Disconnect the battery and test again. The result "replace the battery" can occur due to a weak cable contact. |
| Battery cell faulty - replace | Replace the battery. |
| Connection, Checking | Connect the cable directly to the battery and not to the battery jump start terminal. |
| Battery depleted | Replace the battery. |
Evaluating the Battery Test Results for the Maintenance Test
| Battery Test Result | Measure |
|---|---|
| Battery good | No measure |
| Charge the battery immediately. | Fully charge the battery. Refer to BATTERY, CHARGING . |
| Mark as defective | Mark as defective. |
| Tester Connection, Checking | Disconnect the battery and test again. The result "check the tester connection" can occur because the cable contact is weak. |
| Connection, Checking | Connect the cable directly to the battery and not to the battery jump start terminal. |
| Noises | Wait until the measured value appears in the display. |
| Battery depleted | Replace the battery. |