Voltage Regulator, Removing And Installing, VALEO Generator From 2007: Installing

Fig 1: Feeler Gauge 0.3 Mm -4-, Between Protective Cap -2-, And Carbon Brushes -3-

Courtesy of AUDI OF AMERICA, LLC

-- Push a feeler gauge 0.3 mm -4- between the protective cap -2- and the carbon brushes -3-.

-- Pull the protective cap off until the bar of the protective cap presses the carbon brushes down.

-- After installation of the voltage regulator, press the protective cap all the way on.

Install in reverse order of removal, observing the following:

-- Install the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

• Tightening specification. Refer to OVERVIEW - VALEO GENERATOR FROM 2001 .